Latest article
[Supply of stearyl acrylate] Usage and storage instructions of stearyl acrylate
Octearyl acrylate is a clear liquid. Stearyl acrylate was prepared using microwave synthesis technology using stearyl alcohol and acrylic acid as raw materials, p-toluenesulfonic acid as catalyst and …
[Bite Chemical] List of preparation methods and uses of barium stearate
Barium stearate is in the form of white fine powder. The melting point is 160℃ and the relative density is 1.15. It is insoluble in water, insoluble in cold ethanol, soluble in hot ethanol, benzene, t…
Films are one of the most important uses of ethylene vinyl acetate copolymer (EVA)
Ethylene-vinyl acetate copolymer (EVA) is a general-purpose polymer that is flammable and has no irritating burning smell. Film is one of the most important uses of ethylene-vinyl acetate copolymer (E…
[Supply of Tween 80] Instructions for storage and compatibility of Tween 80
Tween 80 is a non-ionic surfactant and emulsifier. It is an amber oily liquid. Tween 80 has a special odor and a slightly bitter taste. , it becomes gelatinous at low temperatures and recovers after b…
[Bite Chemical] Synthesis and usage industry scope of octadecyldimethyltertiary amine
Octadecyldimethyltertiary amine is a colorless or light yellow transparent liquid, soluble in alcohol but insoluble in water. 1. The synthesis method of octadecyldimethyltertiary amine is as follows: …
Application of styrene-butadiene-styrene block copolymer (SBS) in the shoe rubber industry
Styrene-butadiene-styrene block copolymer (SBS) is white granular, has excellent tensile strength, elasticity and electrical properties, and is permanent Small deformation, good flexibility and resili…
Safety precautions for n-dodecane-Shanghai Beite Chemical Co., Ltd.
n-Dodecane is a colorless liquid. Melting point -9.6℃ (-12℃), boiling point 216.3℃, 145℃ (13.3kPa), 91.5℃ (1.3kPa), relative Chemicalbook density 0.7487 (20/4℃), refractive index 1.4216, flash point 7…
These points should be considered when selecting antioxidants for use in the plastics industry
Plastics usually age rapidly under the action of light, oxygen and heat, resulting in: a decrease in strength, stiffness and toughness; discoloration; scratches and surface Decreased gloss. Affect the…
[Antioxidant supply] There are two ways to add and use antioxidants in the plastics industry.
Antioxidants are a class of chemicals that, when present in only a small amount in a polymer system, can delay or inhibit the oxidation process of the polymer, thus Preventing the aging of polymers an…
Specific application product range and functions of polyolefin elastomer (POE)
It is understood that polyolefin elastomer (POE) is in the form of white granules. It is a high-performance polyolefin that becomes rubber elastic at room temperature. It has low density and It has th…
